Selecting Ports For Mirroring - Nortel 8300 Troubleshooting Manual

Table 3 "Diagnostics, Insert Port Mirrors dialog box fields" (page
51)
Table 3
Diagnostics, Insert Port Mirrors dialog box fields
Field
Id
MirroredPort
MirroringPort
Mode
Enable

Selecting ports for mirroring

Use the following procedure to select ports for port mirroring.
Procedure steps
Step
1
Copyright © 2007, Nortel Networks
.
describes the Diagnostics, Insert Port Mirrors dialog box fields.
Description
An assigned identifier for the configured port mirroring
instance.
Specifies a port to be mirrored (source port). You can
select ports from any module in your configuration by
clicking the ellipses button to the right of the field . See
"Diagnostics, Insert Port Mirrors dialog box" (page
Specifies a destination port (the port to which the
mirrored packets are forwarded). You can select ports
from any module in your configuration by clicking the
ellipses button to the right of the field. See
ports for mirroring" (page
Specifies the traffic direction of the packet being
mirrored—Rx, Tx, or both. The default configuration is
Rx.
Enables or disables this port mirroring instance. The
default value is Enable.
Action
On the device view, select a mirrored (source) port:
a. Click the ellipses button in the MirroredPort field.
The DiagMirrorByPortMirroredPort dialog box appears. See
"DiagMirrorByPortMirroredPort dialog box" (page
DiagMirrorByPortMirroredPort dialog box
b. Select a source port.
c. Click Ok.
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Configuring port mirroring using Device Manager 51
51).
50).
"Selecting
51).