Configuring An Automatic Trace Using The Cli - Nortel 8300 Troubleshooting Manual

146 Troubleshooting tools
Configuring an automatic trace using the CLI
Use the procedures in this section to configure an automatic trace using
the CLI.
The enabling or disabling of auto-trace is not saved to the configuration file. When
a Ethernet Routing Switch 8300 re-boots, the auto-trace functionality is disabled.
Navigation
•
•
•
•
•
•
Enabling an auto-trace
Use the following procedure to enable the trace auto-enable feature.
Procedure steps
Step
1
Variable definitions
Variable
auto-trace <enable|disable>
Adding a module
Use the following procedure to add a module to be traced by the trace
auto-enable feature.
Procedure steps
Copyright © 2007, Nortel Networks
.
"Enabling an auto-trace" (page 146)
"Adding a module" (page 146)
"Removing a module" (page 147)
"Specifying the CPU utilization percentages" (page 148)
"Specifying the time to monitor CPU utilization" (page 148)
"Displaying information about the trace" (page 149)
Action
To enable the trace auto-enable feature, enter the following
command:
trace auto-enable auto-trace enable
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
ATTENTION
—End—
Value
Enables or disables auto-trace. The
default value is disable.