Editing Existing Port Mirroring Values; Sorting Entries; Displaying Configured Port Mirrored Entries - Nortel 8300 Troubleshooting Manual

52 Troubleshooting tools
2
3
4
5

Editing existing port mirroring values

This section describes how to edit existing port mirroring values. The
following topics are covered:
•
•
•
•
•

Sorting entries

You can click on the column heading of any entry listed in the Port Mirrors
tab to sort the entries in ascending or descending numerical order, or you
can sort to group entry values.
Displaying configured port mirrored entries
Use the following procedure to display existing port mirroring entries.
Copyright © 2007, Nortel Networks
.
The Diagnostics, Insert Port Mirrors dialog box displays the new
entry in the MirroredPort field.
Select a destination port.
a. Click the ellipses button in the MirroringPort field.
The DiagMirrorByPortMirroringPort dialog box appears.
b. Select a destination port.
c. Click Ok.
The Diagnostics, Insert Port Mirrors dialog box displays the new
entry in the MirroringPort field.
In the Diagnostics, Insert Port Mirrors dialog box, select the
appropriate mode value (Tx, Rx, or both) to specify the traffic
direction of the mirrored packet. The default configuration is Rx.
Select the appropriate value (Enable or Disable) to enable or disable
this instance of mirroring. The default value is Enable.
Click Insert to accept your configuration choices.
"Sorting entries" (page 52)
"Displaying configured port mirrored entries" (page 52)
"Editing existing mirrored or mirroring ports" (page 54)
"Editing the Mode field values" (page 54)
"Editing the Enable field values" (page 55)
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—