Using Ping Snoop - Nortel 8300 Troubleshooting Manual

138 Troubleshooting tools
Variable
[<ports>]
<session id>
<vid>

Using ping snoop

Use the following sections to configure ping snoop using the NNCLI or CLI.
Navigation
•
•
Configuring ping snoop using the NNCLI
Use the following procedures to configure and enable ping snoop with the
NNCLI.
Navigation
•
•
•
Configuring and enabling ping snoop
Use the following procedure to configure and enable ping snoop.
Prerequisites
•
Procedure steps
Step
1
2
Copyright © 2007, Nortel Networks
.
"Configuring ping snoop using the NNCLI" (page 138)
"Configuring ping snoop using the CLI" (page 140)
"Configuring and enabling ping snoop" (page 138)
"Disabling ping snoop with NNCLI" (page 139)
"Showing ports with ping snoop enabled" (page 140)
You must be in EXEC mode to configure and enable ping snoop using
the NNCLI.
Action
To create the ping snoop filter you must set the SIP and DIP patterns.
Enter the following command:
diag ping-snoop src-ip <ip-mask> dst-ip <ip-mask>
To enable the ping snoop filter on specified ports after the filter has
been created, enter the following command:
diag ping-snoop ports <portlist>
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Value
Specifies the ports for which you are
entering the command in the form portlist
{slot/port[-slot/port][, ...]}.
The session ID. The valid values are 0 to 7.
vid is the VLAN ID. The valid values are 0 to
255.