Advertisement
Available languages
Available languages
Installation
5
The system must be installed and wired only by qualified electricians in
accordance with applicable safety regulations!
For safety, please cut off the mains power switch before installation!
When installing the electrical wiring, please note the nominal amperage
of your incoming feeder.
5.1. Power Wires Installation
5.1.1. Notes for installation:
1.
The UPS must be installed in a location with good ventilation,
faraway from water, inflammable gas and corrosive agents.
2.
Ensure the air vents on the front and rear of the UPS are not
blocked. Allow at least 0.5m of space on each side.
3.
Condensation to water drops may occur if the UPS is unpacked in
a very low temperature environment. In this case it is necessary
to wait until the UPS is fully dried inside out before proceeding
installation and use. Otherwise there are hazards of electric shock.
5.1.2. Installation
Use cable cross section and protective device specification:
6
Aster 6KT
Aster 10KT
Advertisement
