4
Installation Guide
4.1. Method 1: Hook and Loop
Tape Mounting
Step 1. Clean the surface of the area where
the sensor will be installed. Apply
one side of the hook and loop tape
to the bottom of the sensor and the
other side to the sensor location.
Step 2. Attach the sensor on the surface and
hold for about 5 seconds to ensure
cohesion.
NOTE!
Once the sensor is installed, you will want to
leave it in place to ensure the hook and loop
tape.
Step 3. To connect the sensor with PM-
CARD, use the attached RJ45 Eth-
ernet Cable. Plug one end into the
RJ45 Port and the other end into the
PMCARD.
NOTE!
If the distance of PMCARD and the sensor is
longer than 10 feet/3.05 m, use a standard RJ45
Ethernet Cable as needed (max 50 feet/15 m).
6
Universal
Link
RX/TX
PMCARD
4.2. Method 2: Fixed Mounting
Step 1. Drill a hole that is compatible with the anchor and insert the includ-
ed anchor.
Step 2. Insert and tighten the screw into the anchor. Leave enough of the
screw exposed for the sensor to be mounted to.
HoleØ6mm (0.24in)
Step 3. Hang the sensor horizontally or vertically.
7