Njoy Aster 6KT User Manual page 8

6. Connect other input and output wires to the corresponding input and
output terminals according to the following diagram.
Input and output terminal block wiring diagram
Note: Make sure that the input and output wires and the input and
output terminals are connected tightly.
7. It is requested to use the accessorial terminal splices which can be
compacted on the wires tightly, to ensure the connection between
the wires and the terminal block is reliable.
8. Install an output breaker between the output terminal of UPS and
the load, and the breaker should be with leakage current protective
function if necessary.
9. Turn off all the loads first before connecting the load with the UPS,
then perform the connection and finally turn on the loads one by one.
10. After completing the installation, please check the wires to make sure
all were connected correctly and tightly.
11. Suggest charging the batteries for 8 hours before use. After Installation,
turn on the mains power switch and turn the input breaker in the
"ON" position, the UPS will charge the batteries automatically. It can
also use the UPS immediately without charging the batteries, but the
backup time may be less than the standard value.
12. If it is necessary to connect the inductance load such as a electri
engine or a laser printer to the UPS, it must be taken into account
that this kind of loads could have a huge current spike at the start-up
that can exceed the UPS's capacity and easily trigger the overload
protection in the UPS, which will halts the UPS into error state and
shuts down the electrical power.
8
Fig. 3