Table of Contents
Advertisement
Master Scale Kit Edition Classic Ugly Stick 70.9"
C/A glue.
Fuel pick up tube.
9) Connect the lines from the tank to the en-
gine and muler. he vent line will connect
to the muler and the line from the clunk to
the carburetor.
46
Ignition Module.
B
Balsa wood.
Vent tube.
Fuel ill tube.
Instruction Manual.
Blow through one of the lines to ensure
the fuel lines have not become kinked inside
the fuel tank compartment. Air should low
through easily.
ENGINE MOUNT INSTALLATION.
1) Locate the items necessary to install
the engine mount included with your
model.
4x30mm
2) Use four 4x30mm head bolts and four
4mm washers to attach the engine mount
rails to the irewall. Tighten the screws .
Make sure to use threadlock on the screws
to help prevent them from vibrating loose.
hread locker glue.
MOUNTING THE ENGINE.
1) Position the engine with the drive
washer (140mm) forward of the irewall
as shown.
.
Advertisement
Table of Contents
