Seagull Models MASTER SCALE KIT EDITION CLASSIC UGLY STICK 70.9 Assembly Manual page 18

Master Scale Kit Edition Classic Ugly Stick 70.9"
- Locate and assemble fuselage front S1
and fuselage rear S1B, join them by S3.
Repeat for the other fuselage side using
S2 front and S2B rear. Lay lat on plastic
surface an apply CA glue. Wipe of any
excess glue before it dries so that there
won't be a glue lump at the joint.
-Locate and assemble the fuselage side
doublers S1A and from nose to wing seat,
use white glue to secure. Repeat S2A for
the other fuselage side. Allow glue to set
before proceeding. Make sure you have
assembled them as shown so that you
end up with both a let and right fuselage
side.
- Locate and assemble 3 layer for motor
mount ( MO); 3 layer for engine mount (
F1) and 2 layer for ring (ER)
- Locate and assemble 2 layer for F2 and
F2A
- Locate and assemble 4 layer for land-
ing gear M4A( 1pcs), M4B(2pcs) ,
M4C(1pcs); 3 layer for landing gear
M5A( 1pcs), M5B(2pcs) ; 3 layer for wing
mount M3A( 1pcs), M3B(2pcs).
2.
- Locate and assemble F2(F2A) dou-
blers and battery/ fuel tank mount M1 as
picture
18
Instruction Manual.
3.
4.
- Locate and assemble F2 doublers,
mount M1 and landing gear mount M4
(4 layers) to fuselage side as shown.
5.
6.