Seagull Models MASTER SCALE KIT EDITION CLASSIC UGLY STICK 70.9 Assembly Manual page 44

Instruction Manual.
Master Scale Kit Edition Classic Ugly Stick 70.9"
THROTTLE SERVO ARM
INSTALLATION.
.
Install adjustable servo connector in the
servo arm as same as picture below:
Adjustable servo
connector.
Switch.
Loctite
secure.
Servo arm.
INSTALLING THE ENGINE SWITCH.
.
hrottle servo arm.
Trim and cut.
INSTALLING THE RECEIVER SWITCH.
Install the switch into the precut hole in
the side, in the fuselage.
Switch.
3/32" Hole.
INSTALLING THE STOPPER
ASSEMBLY.
1) Using a modeling knife, carefully cut
of the rear portion of one of the 3 nylon
tubes leaving 1/2" protruding from the
rear of the stopper. his will be the fuel
pick up tube.
2) Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
Trim and cut.
the other end to the nylon pick up tube.
44