Seagull Models Aviat A-1C Christen Husky 80 Assembly Manual page 17

2.
3.
Position the engine with the drive washer
(145mm) forward of the iewall as shown.
4.
Use a pin drill and 4mm drill bit to drill
a small indentation in the mount for the
engine mounting screw.
head locker glue
145mm
5.
Use a drill to drill the four holes in the
engine mount rails.
6.
On the ie wall has the location for the
throttle pusshrod tube (pre-drill).
Slide the pushrod tube in the iewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the ie-
wall and the fuel tank mount.
Connect the Z-bend in the 450mm
throttle pushrod to the outer hole of the
carburetor arm.
Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four M4x30mm machine
screws to secure the engine to the mount
as shown.
4mm
17