Configuration - wtw pH 3300i Operating Manual

Operation
Baud rate
(pH 3400i)
46
4.6

Configuration

You can adapt the measuring instrument to your individual requirements. To
do this, the following parameters can be changed (the status on delivery is
marked in bold):
Baud rate
Display during the
pH calibration
Calibration interval (Int 3)
Date/time
pH resolution
Note
You can leave the configuration menu at any time with <M> . The parameters
that have already been changed are stored.
1 Switch off the measuring instrument.
2 Press the <M> key and hold it down.
3 Press the <ON/OFF> key.
The display test appears briefly on the display. The measuring instru-
ment then switches automatically to the setting of the baud rate.
TDS UpH O
S
1 n t 2
4 8 0
Time Baud
Day.Month No.
Year Ident
Tref20
Tref25 AutoCal DIN
LoBat
nLF Lin Cal AutoCal TEC
4 Select the required Baud rate with <▲> <▼>.
5 Confirm with <RUN/ENTER>.
CAL diSP appears on the display.
1200, 2400, 4800, 9600
Buffer nominal value, or current
electrode voltage
1 ... 7 ... 999 d
Any
0.01 or 0.001
Sal
mV/pH
% mg/l
m S/
cm
mbar M cm
1/ cm Sal
0
°
C
/
% K
TP
° F
Auto
Store
ARng
AR RCL
pH 3300i/3400i
ba75682e02 03/2008