Outputting The Data Storage - wtw pH 1970i Operating Manual

pH 1970i
Outputting stored data
on the display
ba75690e01 01/2007

4.4.3 Outputting the data storage

You can output the contents of the data storage:
Stored data on the display
Calibration data on the display
Stored data on the serial interface
Calibration protocol on the interface
1 Press the <RCL> key repeatedly until StO dISP appears on the
display.
pH S
I S T
O
Sal
Time Baud
D I S
Day.Month No.
Year Ident
Tref25 Tref20 Auto Store
LoBat nLF Lin Oxi Cal TEC
2 Press the <RUN/ENTER> key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
pH S
6 8 7
1
O
Sal
Time Baud
8 2 4 8
Day.Month No.
Year Ident
Tref25 Tref20 Auto Store
LoBat nLF Lin Oxi Cal TEC
You can perform the following activities:
Display further elements of the data record
(ID number, date, time, storage location)
Advance one data record (storage location)
Go back one data record (storage location)
mV / pH
o
%
mg/l
S/
m
cm
1/ cm Sal
P
C
°
/ K
%
TP
REL1 REL2
ARng AR RCL
mV / pH
% mg/l
S/
m
cm
1/ cm Sal
C
°
/
% K
TP
REL1 REL2
ARng AR RCL
Operation
Press
<RUN/ENTER>
Press <L>
Press <M>
37