Connectors: Antenna; Module Leds - Digi Connect ME Hardware Reference Manual

Connectors: Antenna

Module LEDs

13
      
Downloaded from Elcodis.com electronic components distributor
The Digi Connect Wi-ME is available with 1 RP-SMA connector. The antenna is
connected to the module with a reverse polarity SMA connector (sub-miniature size A).
The antenna only fits on the module one way to ensure a proper connection. Another option
for both signal reception and design flexibility is to use an antenna extension cord to
separate the antenna from the module. This allows the module to fit inside your product but
the antenna to be placed outside the device.
Caution: This Part 15 radio device operates on a non-interference basis
with other devices operating at this frequency when using the antennae
listed in the Antenna Specification table. Any changes or modification to
the product not expressly approved by Digi International could void the
user's authority to operate the device.
Type
Part number DC-ANT-24DT
Gain
The module has two LEDs that are located near the upper corners of the Ethernet port (see
the following figure). The following table describes the LEDs.
The LEDs are the same for a module with or without a JTAG connector.
Note:
Antenna Specifications
Desktop Dipole
DG-ANT-20DP-BG
1.8 dBi 2 dBi
30 cm
Antenna Extension Cord
DG-EXT-300-RR
-.5dB