Body Solid GCEC-340 Manual page 10

S T E P
Ь Я Be careful to assem ble all com ponents
in the sequence they are presented.
N O T E : Finger tighten all hardware in this step.
A. Connect Leg Hold Down (C) to Leg Extension Frame (B) using:
T w o 2 (M 1 2 x 7 5 h e x head bolt)
T w o 8 (M 1 2 w a s h e r)
T w o 6 (M 1 2 nylon nut)
B. Connect Leg Hold Down (C) and Left Leg Hold Down (J) to Main Base Frame (A) using:
T w o 1 (M 1 2 x 8 0 h e x head bolt)
T w o 6 (M 1 2 nylon nut)
C. Insert Round End Cap (22)
D. Insert Round End Cap (22) into Leg Hold Down (C).
E. Connect two Plates (M) to Main Base Frame (A) as shown using:
O ne 3 (M 1 0 x 8 0 h e x head b olt)
T w o 9 (M 1 0 w a s h e r)
O ne 7 (M 1 0 nylon nut)
F. Connect the remaining two
O ne 3 (M 1 0 x 8 0 h e x head b olt)
T w o 9 (M 1 0 w a s h e r)
O ne 7 (M 1 0 nylon nut)
G. Attach Seat Pad (N) to Plate (M) using:
Four 5 (5 /i6" x 1 1 /4 h ex head bolt)
Four 11 (5 /16" spring w a s h e r)
Four 10 (5 /16" w a s h e r)
H. Insert both Nylon Bushings (19) into Main Base Frame (A).
I. Insert both End Caps (14) into Adjustable Tube (I).
J. Insert Adjustable Tube (I) into Main Base Frame (A) and secure using T-Shaped Pop Pin (31).
K. Slide Roller Bar (P) into Adjustable Tube (I).
L. Slide Foam Roller (23) onto both sides o f Roller Bar (P).
M. Slide Nylon W asher (27) onto both sides of Roller Bar (P).
N. Insert Round End Cap (26) onto both sides of Roller Bar (P).
10
0
m
Do Not w rench tighten until the end of Step 3.
into Left Leg Hold Down (J).
Plates (M) to Main Base Frame (A) as shown using:
20 30 40 50 60 70 80 90 100
10
110 120 130 140 150
6 "