Table of Contents
Advertisement
1
Using the Probe
Using the Accessory Tips and Grounds
9 cm Y-Leads with
0.1" Headers
18
Like the 6 cm Y- leads, the 9 cm Y- leads
offer a convenient and reliable method to
connect both the probe signal and ground
to probe points on the board via or the
solderable pins that are provided with
each probe. The added convenience of the
longer leads results in a slightly reduced
bandwidth.
The sockets accept 0.56 to 0.86 mm round and 0.64 mm
square (0.022 to 0.034 inch round and 0.025 inch square)
diameter pins. The maximum insertion depth is 7.5 mm
(0.295 inch) and the outer insulation of the socket is less
than 2.54 mm. You can use it for 2.54 mm pitch (0.1 inch)
terminals.
Figure 7
Probe with Y-Leads Attached
N2797A User's Guide
Advertisement
Table of Contents
