Configure A Single Path Alarm Connection - DMP Electronics CellComSLCF Application Note

Configure a Single Path Alarm Connection

Some fire panels provide two telco connections. Because the CellComSLCF is equipped with a single telco
connection, the fire panel must be configured accordingly. One method of installation is to disable the second
telco connection. If this option is not applicable due to panel limitations, both TIP and RING connections may be
connected from the panel into the CellComSLCF. The CellComSLCF has the capability of monitoring and providing a
dial tone to both telco connections.
1. Connect both phone lines on the host panel to TIP and
RING on the CellComSLCF.
MODEL CellCom
B R
8 0 0 - 6 4 1 - 4 2 8 2
w w w . d m p . c o m
Designed, Engineered and
Assembled in U.S.A.
J8
J9
S3
+12 G Z1 Z2 Z3 G Z4+ Z4-
PRI. PHONE LINE SEC. PHONE LINE
ALARM PANEL
I N T R U S I O N • F I R E • A C C E S S • N E T W O R K S
2 5 0 0 N o r t h P a r t n e r s h i p B o u l e v a r d
S p r i n g fi e l d , M i s s o u r i 6 5 8 0 3 - 8 8 7 7
S1
RESET
S1
S2
LOAD
S2
O1 O2 T R