Table of Contents
Advertisement
Getting Started
STEP 4. Install the Network Analyzer Modules
Tools Required for the Installation Procedure
— Phillips #1 torque driver, set to 4 in-lbs (0.45 N.m) - not supplied.
— Socket adapter (part number 5023-1450) - supplied.
— Torque driver (for use with socket adapter), set to 8 in-lb (0.91 N.m) - not
supplied.
— Cable removal tool (part number 5002-3361) - supplied.
Installation Procedure
PXI hardware does not support "hot-swap" (changing network analyzer
modules while power is applied to the chassis) capabilities. Before
installing or removing a module to/from the chassis, power-off the chassis
to prevent damage to the module.
1. Make sure that the line cord is plugged in to establish earth ground and
that the chassis power switch is Off (see callouts 1 and 3 in
page
13).
2. Wear a grounded wrist strap for this procedure (see callout 2 in
on page
3. If the chassis has multiple fan speed settings, ensure that the fan switch is
set to AUTO.
4. Position the chassis to provide ample space between the chassis fan
intake and exhaust vents. Blockage by walls or obstructions affects the air
flow needed for cooling. (Refer to the chassis documentation for more
information about cooling.)
5. Before inserting the network analyzer module into the chassis, back-out
the top mounting screw (see callout 7 in
module to ensure that there is no interference between the screws and the
mounting rails.
6. Holding the module by the injector/ejector handle, slide it into a slot, as
shown in callouts 4 – 6 in
a. Install the module into the slot of the chassis by placing the module
card edges into the front module guides (top and bottom).
12
The network analyzer module can be installed in any PXIe or hybrid PXI
slot marked with a peripheral slot compatibility image (solid black
circle fro PXIe, or solid black circle with the letter "H" for hybrid.
13).
Figure 1-3 on page
Figure 1-3 on
Figure 1-3 on page
13) on the
13.
Keysight Technologies Startup Guide
Figure 1-3
Advertisement
Table of Contents
