Table of Contents
Advertisement
1
Installation
To install the Nanospray Slide Assembly for inline analysis
Do these steps to change the
Orthogonal Orientation
Sideways
Before you begin, make sure that you have the
Do not change the
WA R N I N G
turned on. The high-voltage region inside of the source can cause bodily harm.
1 Make sure that the LC/MS instrument is in Standby mode or turned off.
2 Remove the
3 Loosen the four captured Torx T10 screws that attach the
Figure 29
4 Remove the
36
Orientation.
Nanospray Slide Assembly
Needle Sleeve Assembly
present.
Assembly
to the top of the Nanospray Ion Source.
Four captured screws attach the
Ion Source.
Nanospray Slide Assembly
Nanospray Slide Assembly
to either the
Inline Horizontal Orientation
configuration when the system is
from the
Nanospray Slide Assembly
from the spray chamber.
from the standard
Camera Plate
and
Camera
Nanospray Slide
Assembly, if
Nanospray Slide
to the Nanospray
Nanospray Ion Source User Guide
or
Inline
Plug.
Advertisement
Table of Contents
