Table of Contents
Advertisement
1
Installation
To install the power cord and camera
1 Plug in the power source and camera power cords:
Figure 14
2 Install the video capture card into the computer and load the software.
3 Connect the camera to the video capture cards:
22
a Locate the power contacts on the lower-right of the spray chamber.
Power contacts
b Plug the camera power cord into either of the two power contacts.
c Plug the 12V DC power supply for the source into the remaining power
contact. Plug the other end to the wall outlet.
The internal LED light glows with a red light. The fan at the rear of the
source turns on.
Follow the manufacturer's instructions.
a Connect the yellow male RCA plug from the video capture card to one
female end of the BNC adapter (p/n 1250-3410).
b Connect the yellow female BNC plug from the camera to the BNC
adapter.
Nanospray Ion Source User Guide
Advertisement
Table of Contents
