Omron HD-1500 Assembly Instructions Manual page 87

LIGHTS
The LIGHTS connector on the User Access Panel provides outputs for user-supplied signaling devices
such as warning lights or buzzers.
Use the information below to understand all LIGHTS connections.
The following figure shows the pin arrangements for the LIGHTS connector on the AMR.
PIN 4
PIN 6
The information in the table below describes the signal designations for the I/O 1 connector.
*1. The buzzer signal will turn ON when the AMR warning buzzer turns ON.
Refer to the following sections for information about the behavior of the LIGHT signals.
• 2-6-5 LIGHTS Connector on page 2-16
I/O 1
The I/O 1 connector on the User Access Panel provides analog and digital inputs for user-supplied de-
vices that are typically used for control of a payload structure system. Use the information below to
understand all I/O 1 connections.
The following figure shows the pin arrangements for the I/O 1 connector on the AMR.
PIN 11
PIN 20
The information in the table below describes the signal designations for the I/O 1 connector.
HD-1500 Platform Assembly Instructions (18407-150)
PIN 1
PIN 3
Pin Number
1
2
3
4
5
6
PIN 1
PIN 10
Description
Red light
Ground
Yellow light
Green light
Ground
*1
Buzzer
3 Installation
3
3-13