Showven SPARKULAR JET User Manual page 9

b) Make sure the machine is securely installed to avoid tipping.
4. Connect SPARKULAR
a) Make sure power supply in consistent with the rated voltage of the equipment, and the
socket must well grounded.
b) Maximum cascade of SPARKULAR
power cable. Do not connect exceed units to a single electrical circuit.
c) If use together with HOST CONTROLLER ZK6200/6300, each unit of SPARKULAR
set unique DMX address, otherwise it may leads to signal interference.
d) Suggest to plug in a DMX terminator into the DMX out in last unit of machine.
e) Turn on host controller and SPARKULAR
5. Activate SPARKULAR
a) Swipe an RFID card. Read the card as show below. SPARKULAR JET screen flash once if read
successfully.
b) SPARKULAR JET will report E4 when remaining firing times is less than 10mines.
®
c) Please note each RFID card come with 200g package HC8200 can increase single machine 30
firing times, the maximum recharge times each time for SPARKULAR
when remaining firing times reached 120, it can't recharge anymore RFID card.
CN. 00000001
6. Clear material
Run clear material for all SPARKULAR
controller or turn DMX value to 60-80 on second channel.
JET and Host Controller with power / DMX cable
®
JET is 6 units (BT91) / 3 units (BT92) with a standard
®
JET.
®
JET by swipe RFID card
®
JET before firing by press "CLEAR" button on host
®
JET must
®
JET is 120 times,
®