Connecting To A 100-Pin 0.5Mm Pitch Foot Pattern (Part 3) - Renesas R0E3308B0EPB00 User Manual

R0E3308B0EPB00 User's Manual

2.9.3 Connecting to a 100-pin 0.5mm pitch Foot Pattern (Part 3)

Figure 2.10 shows how to connect the emulation probe to a 100-pin 0.5mm pitch foot pattern on the user system with the M3T-
F160-100NSD (not included), and here following is its procedure. For details on the M3T-F160-100NSD, refer to its user's
manual.
(1) Mount the NQPACK100SD included with the M3T-F160-100NSD to the user system.
(2) Attach the YQPACK100SD included with the M3T-F160-100NSD to the NQPACK100SD.
(3) Insert the YQ-GUIDE's included with the YQPACK100SD to the YQPACK100SD.
(4) Attach the M3T-F160-100NSD to the YQPACK100SD.
(5) Attach the R0E3308B0EPB00 to the M3T-F160-100NSD.
These corners are not round.
*: These four items are available in one package .
Figure 2.10 Connecting to a 100-pin 0.5mm pitch foot pattern (3/3)
Notes on Connecting the User System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator.
• The small connectors of the R0E3308B0EPB00 and M3T-F160-100NSD are guaranteed for only 50
insertion/removal iterations.
• NQPACK, YQPACK, YQ-GUIDE, HQPACK are products of Tokyo Eletech Corporation.
R20UT0210EJ0200 Rev.2.00
Sep 16, 2010
M3T-FLX160-EPB
R0E3308B0EPB00
CN2 side
(5)
(4)
YQ-GUIDE (x4)
*
YQPACK100SD
(3)
(2)
100-pin 0.5mm pitch
(100P6Q) foot pattern
(1)
No. 1 pin
CAUTION
M3T-F160-100NSD
(not included)
On-board evalution
HQPACK100SD
(not included)
FLASH MCU etc.
NQPACK100SD
User system
2. Setup
Page 33 of 98