Inner Chute Assy - Brother MFC-J2320 Service Manual

Assembling Note: Attach the Drive unit, using the following steps.
1) Attach the Shaft and Gear to the Drive unit.
2) After aligning the two Shafts with the D cutouts in the Maintenance unit, attach the Drive
unit to the Maintenance unit.
D cutouts
(Align with Shafts)

9.47 Inner Chute ASSY

(1) Release the wiring of the Registration sensor PCB ASSY.
(2) Remove the screw (TAPTITE CUP B M3x10) and the two screws (TAPTITE BIND
B M3x10).
(3) Remove the Frame base stopper ring, lift up the rear end of the Frame base, and
take it off the Lower cover.
Frame base
stopper ring
TAPTITE BIND B M3x10
Maintenance unit
Fig. 3-120
TAPTITE CUP B M3x10
TAPTITE BIND B M3x10
Frame base
Fig. 3-121
3-105
Gear
Shaft
Drive unit
Confidential