9.13 Second Side CIS Flat Cable (Duplex scanning models only)
(1) Open the Feed tray.
(2) Remove the Feed tray.
(3) Remove the four screws (TAPTITE CUP B M3x10), take off the Upper document
chute, and temporarily put it in place.
Note: Do not remove the harness of the Upper document chute.
Assembling Note: When attaching the four screws (TAPTITE CUP B M3x10), observe
the order indicated below.
(4) Pull out the Second side CIS flat cable from the Upper document chute.
ADF unit
1
Harness
Upper document chute
Feed tray
Fig. 3-35
4
Second side
CIS flat cable
3
Fig. 3-36
3-46
2
Confidential