9.60 Inner Chute ASSY
(1) Take off the Gear shift prevention block.
(2) Release the wiring of the Registration sensor harness.
(3) Remove the Resin retaining ring from the Frame base.
(4) Remove the one screw (TAPTITE CUP B M3x10) to release the Engine FG wire
from the Frame base.
(5) Remove the two screws (TAPTITE CUP B M3x10) and remove the Frame base.
TAPTITE CUP B M3x10
<Front>
Resin retaining ring
Frame base
Fig. 3-145
3-121
TAPTITE CUP B M3x10
<Rear>
Engine
FG wire
Registration
sensor harness
Gear shift
prevention block
Confidential