Characteristics And Environmental Conditions - Keysight Infiniium S Series Service Manual

Characteristics and Environmental Conditions

The following table contains a partial list of specifications and characteristics for
the Infiniium S-Series oscilloscopes. For a full list of specifications and
characteristics, see the data sheets at www.keysight.com/find/S-series.
Warranted specifications are tested in
30-minute warm-up period, and within
last user calibration was performed.
Environment
Ambient temperature
Humidity
Altitude
Weight
Dimensions
Safety
Installation Category
Power Requirements
Voltage Fluctuations
Pollution Degree
Pollution Degree
Definitions
S-Series Oscilloscopes Service Guide
Chapter
±
5
Indoor use only
Operating: 5 °C to +40 °C
Non-operating: –40 °C to +65 °C
Operating: up to 80% relative humidity (non-condensing) at +40 °C
Non-operating: up to 90% relative humidity at +65 °C
Operating: up to 3,000 meters (9,842 feet)
Non-operating: up to 15,300 meters (50,000 feet)
11.8 kg (26 lbs)
16.8 in (43 cm) wide, 12.9 in (33 cm) tall, and 9 in (23 cm) deep
rd
UL61010-1 3 edition
CAN/CSA-22.2 No. 61010-1-12 3
II
100-120 V, 50/60/400 Hz
100-240 V, 50/60 Hz
380 W Max
Note that the main supply voltage fluctuations are not to exceed ±10% of
the nominal supply voltage.
The Infiniium S-Series oscilloscopes may be operated in environments of
Pollution Degree 2.
Pollution Degree 1: No pollution or only dry, non-conductive pollution
occurs. The pollution has no influence. Example: A clean room or
climate-controlled office environment.
Pollution Degree 2. Normally only dry non-conductive pollution occurs.
Occasionally a temporary conductivity caused by condensation may occur.
Example: General indoor environment.
Pollution Degree 3: Conductive pollution occurs, or dry, non-conductive
pollution occurs which becomes conductive due to condensation which is
expected. Example: Sheltered outdoor environment.
General Information
3. Specifications are valid after a
°
C from the temperature at which the
rd
edition
1
11