Mercedes-Benz AMG GT Operator's Manual page 191

188 Driving and parking
Use the DIRECT SELECT lever to switch the trans-
mission position. The current transmission posi-
tion will be shown on the instrument display.
Park position
j
Reverse gear
k
Neutral
i
Drive position
h
▌Engaging reverse gear R
Depress the brake pedal and push the DIRECT
#
SELECT lever upwards past the first point of
resistance.
▌Engaging neutral N
Depress the brake pedal and push the DIRECT
#
SELECT lever up or down to the first point of
resistance.
%
To shift into neutral i with the vehicle
switched on, push the selector lever up or
down for several seconds to the first point of
resistance.
Subsequently releasing the brake pedal will allow
you to move the vehicle freely, e.g. to push it or
tow it away.
Proceed as follows if you want the automatic
transmission to remain in neutral i even if the
vehicle is switched off or the driver's door is
opened:
Depress the brake pedal and engage neutral
#
i when the car is stationary.
Release the brake pedal.
#
Switch off the vehicle.
#
%
If you then exit the vehicle leaving the key in
the vehicle, the automatic transmission
remains in neutral i.
▌Engaging park position P
* NOTE Damage due to engaging park posi-
tion j while the vehicle is rolling
If you shift the transmission into park position
j while the vehicle is rolling, the transmis-
sion may be damaged.
If the vehicle is rolling, do not open a
#
door.
Only engage the park position j when
#
the vehicle is stationary.
Observe the notes on parking the vehicle
#
( page 207).
/
Depress the brake pedal until the vehicle
#
comes to a standstill.
When the vehicle is stationary, press button
#
j.
When the transmission position display shows
j, the park position is engaged. If the trans-