Table of Contents
Advertisement
Issue Service User Combination
This operation issues a one-time combination for a Service User that can be
used to open the lock.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User
Enter the Master User or Manager User combina-
or Manager User
tion. The lock will beep/flash the green LED on each
combination
keystroke entered. If the Clear key is pressed dur-
ing data entry, the lock responds with one beep/
flash of the green LED followed by the red LED, and
all digits of the combination must be re-entered. The
lock responds with three beeps/flashes of the green
LED to indicate available entry. If the combination is
not valid, the lock responds with three beeps/flashes
of the red LED.
3.
Press
then 92.
Before re-lock time expires, press
followed by the 9 key and then the 2 key. The lock
responds with two beeps/flashes of the green LED.
4.
Enter new Service
Enter the Service User Combination (User ID +
User combination.
PIN). The lock responds with two beeps/flashes of
the green LED.
Note: The Service User is added with a combination (User ID + PIN).
When PIN length = 0, Combination = User ID only; otherwise,
Combination = User ID + PIN. Do not set Service User PIN to all 0's.
All users, regardless of personnel classification, will occupy one of the available
User ID positions when added to the lock. A User ID is unique to a particular
user; i.e., no two users can have the same User ID.
5.
Enter new Service
Enter the Service User Combination again for
User combination
verification. The lock responds with two simulta-
again.
neous beeps/flashes of the green and red LEDs if
the combination was verified successfully. The
lock responds with two beeps/flashes of the red
LED to indicate an error.
The Service User combination is now available.
20
Remove Service User Combination
This operation removes a one-time combination that was issued for a Service
User so that it is not available to open the lock.
Step
1.
Power lock.
2.
Enter Service User
combination.
(Enter key)
Detailed Instructions
Power the lock by depressing the outside lever.
Enter the Service User combination. The lock
will beep/flash the green LED on each keystroke
entered. If the Clear key is pressed during data
entry, the lock responds with one beep/flash of
the green LED followed by the red LED, and all
digits of the combination must be re-entered. The
lock responds with three beeps/flashes of the
green LED to indicate available entry. If the
combination is not valid, the lock responds with
three beeps/flashes of the red LED.
The Service User combination is now deactivated.
21
Advertisement
Table of Contents
