Table of Contents
Advertisement
Disable a Specific User ID
This operation allows the Master User or Manager User to restrict access to the
lock for a specific Access or Service User.
Note: The Master User and Manager User cannot be disabled.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User
Enter the Master User or Manager User combina-
or Manager User
tion. The lock will beep/flash the green LED on
combination
each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/
flash of the green LED followed by the red LED, and
all digits of the combination must be re-entered. The
lock responds with three beeps/flashes of the green
LED to indicate available entry. If the combination is
not valid, the lock responds with three beeps/flashes
of the red LED.
3.
Press
then 70.
Before re-lock time expires, press
followed by the 7 key and then the 0 key. The lock
responds with two beeps/flashes of the green
LED.
4.
Enter User ID.
Enter the User ID to be disabled. The lock responds
with two beeps/flashes of the green LED.
The selected User ID is disabled.
5.
Repeat Step 4 to
Repeat Step 4 to disable additional User IDs or
disable additional
go to Step 6.
User IDs or go to
Step 6.
6.
Press
to exit.
Press
lock responds with two simultaneous beeps/
flashes of the green and red LEDs and exits the
procedure.
22
(Enter key)
(Enter key) to exit this procedure. The
Enable a Specific User ID
This operation allows the Master User or Manager User to enable access to the
lock for a specific Access or Service User.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User
Enter the Master User or Manager User combina-
or Manager User
tion. The lock will beep/flash the green LED on
combination
each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/
flash of the green LED followed by the red LED, and
all digits of the combination must be re-entered. The
lock responds with three beeps/flashes of the green
LED to indicate available entry. If the combination is
not valid, the lock responds with three beeps/flashes
of the red LED.
3.
Press
then 71.
Before re-lock time expires, press
followed by the 7 key and then the 1 key. The lock
responds with two beeps/flashes of the green LED.
4.
Enter User ID.
Enter the User ID to be enabled. The lock responds
with two beeps/flashes of the green LED.
The selected User ID is enabled.
5.
Repeat Step 4 to
Repeat Step 4 to enable additional User IDs or go
enable additional
to Step 6.
User IDs or go to
Step 6.
6.
Press
to exit.
Press
lock responds with two simultaneous beeps/ flashes
of the green and red LEDs and exits the procedure.
(Enter key)
(Enter key) to exit this procedure. The
23
Advertisement
Table of Contents
