8.2
Format of Log File
The following shows an example of the log file when the check results show "OK" statuses.
Execution time
Execution time
Clock status
Clock status
V
V
DD
DD
Reset status
Reset status
Hardware
Hardware
version
version
Check result
Check result
• Execution time:
• Clock status:
• V
status:
DD
• Reset status:
• Hardware version:
Remark
The version of the 78K0S MINICUBE+ can be checked on the following NEC Electronics
websites. For the latest version, consult an NEC Electronics sales representative or distributor.
Japanese version:
English version:
See Version-up service → MINICUBE2_Software.
46
CHAPTER 8 OCD CHECK FOR 78K0S MINICUBE+
tt:mm:ss
tt:mm:ss
Target Clock: 10.00MHz [OK]
Target Clock: 10.00MHz [OK]
status
status
Target Power: POC
Target Power: POC
Target Reset: HIGH
Target Reset: HIGH
OCD Control Code Vx.xx
OCD Control Code Vx.xx
MINICUBE 78K0S 2000 x xx.xx
MINICUBE 78K0S 2000 x xx.xx
Control Board
Control Board
I/O Board
I/O Board
ALL OK
ALL OK
Emulator Test End
Emulator Test End
The time when checking was started by clicking the [Test] button.
Frequency of the selected clock
[ON]
Power supply to the QB-78K0SKX1-DA and target system are on
[POC]
Power supply to the QB-78K0SKX1-DA is on and power supply to the
target system is off
[OFF]
Power supply to the QB-78K0SKX1-DA is off (NG)
RESET pin status
[HIGH]
Reset signal input from the target system is HIGH
[LOW]
Reset signal input from the target system is LOW
Version of each hardware.
http://www.necel.com/micro/ods/jpn/index.html
http://www.necel.com/micro/ods/eng/index.html
User's Manual U18591EJ2V0UM
0001 xx.xx
0001 xx.xx
0100 00.03 xx.xx
0100 00.03 xx.xx