Format Of Log File - Renesas MINICUBE QB-MINI2 User Manual

CHAPTER 3 OCD CHECK FOR MINICUBE2 AND 78K0 MICROCONTROLLER
3.2

Format of Log File

The following shows an example of the log file when the check results show "OK" statuses.
Execution time Execution time
Clock status Clock status
V V
DD DD
Reset status Reset status
Hardware version Hardware version
Check result Check result
• Execution time: The time when checking was started by clicking the [Test] button
• Clock status:
Frequency of the selected clock
• V
status: V
DD
• Reset status:
RESET pin status
• Hardware version: Version of each hardware.
• Check result: [Program Download] ID verification, result of downloading to flash memory in the target
[Run Test]
[Flash Erase] Erasure result of flash memory in the target device
Remark The version of MINICUBE2 can also be checked with the MINICUBE2 diagnostic tool, debugger and
QBP. The latest version of MINICUBE2 firmware can be checked on the following NEC Electronics
websites.
Japanese version:
English version:
See Version-up service → MINICUBE2_Software.
16
status status
value that is applied to the target device
DD
[HIGH] Reset signal input from the target system is HIGH
[LOW] Reset signal input from the target system is LOW
device
Result of executing and stopping the program
http://www.necel.com/micro/ods/jpn/index.html
http://www.necel.com/micro/ods/eng/index.html
User's Manual U18591EJ2V0UM
tt:mm:ss tt:mm:ss
Target Clock: 20.00MHz [OK] Target Clock: 20.00MHz [OK]
Target Power: 5.1V [OK] Target Power: 5.1V [OK]
Target Reset: HIGH Target Reset: HIGH
OCD Control Code Vx.xx OCD Control Code Vx.xx
MINICUBE2 4100 x xx.xx MINICUBE2 4100 x xx.xx
Program Download: OK Program Download: OK
Run Test: OK Run Test: OK
Flash Erase: OK Flash Erase: OK
ALL OK ALL OK
Emulator Test End Emulator Test End