Table of Contents
Advertisement
CHAPTER 3 OCD CHECK FOR MINICUBE2 AND 78K0 MICROCONTROLLER
3.3
Error Output
The following describes the operation and display example when an NG is displayed as a result of 3.1 Execution
of OCD Check. The message just indicates "NG", but there are various causes.
(1) The result is displayed in the dialog box. Click the [OK] button.
(2) The contents displayed in the log view window are saved in the log file.
[Log view window]
[Log file]
Execution time
Execution time
Clock status = OK
Clock status = OK
Error indication
Error indication
Hardware version
Hardware version
In this NG example, the monitor command (3FH) error and communication error are output.
The communication failure between the target device and MINICUBE2 is detected. The cause is an error in
the target cable connection between the target system and MINICUBE2.
(1)
(1)
tt:mm:ss
tt:mm:ss
Target Clock: 20.00MHz [OK]
Target Clock: 20.00MHz [OK]
Monitor Command(3FH) Error
Monitor Command(3FH) Error
Communication Error
Communication Error
MINICUBE2 4100 x xx.xx
MINICUBE2 4100 x xx.xx
Emulator Test End
Emulator Test End
User's Manual U18591EJ2V0UM
17
Advertisement
Table of Contents
