Table of Contents
Advertisement
Setting Up the Chassis
3.2.3
Rack Mounting the Chassis
When installing the N3 chassis into a standard 48.26-centimeter (19-inch) equipment rack,
•
allow at least 61 centimeters (24 inches) of clearance in front and behind the rack for chassis
installation and maintenance, and
•
keep in mind that the chassis requires at least 36 centimeters (15 inches) of vertical rack space.
Note: In order to prevent a possible interference between the rack frame front and chassis rack
ears, the tapped rails may need to be adjusted such that they are recessed approximately 2 inches
behind the rack frame front. If the rack has a front door, this distance may need to be slightly more
depending on the door thickness.
Caution: Read
guidelines are met.
Precaución: Antes de llevar a cabo el siguiente procedimiento, lea
cumplir con todos los requisitos de instalación.
To install the chassis, refer to
Warning: To help prevent personal injury, at least two people are required to lift the chassis into the
rack.
Advertencia: Para ayudar a prevenir alguna lesión personal , al menos dos personas son
requeridas para levantar el chasis y meterlo al rack.
Warnhinweis: Zum Schutz vor körperlichen Schäden, sollten sie mit min. zwei Personen das
Chassis in das Rack heben.
1. Determine the location where you want to install the chassis in the rack.
2. Lift the chassis to align the holes in the chassis side rails with the tapped holes in the rails of the
rack.
3. Use the seven 10-32 screws shipped with the chassis to secure the chassis to the rack, starting
with the bottom holes and working toward the top of the chassis.
NOTE: Refer to
N3 chassis using standard threaded fastener machine screws and bolts.
3-4
Chassis Setup
Chapter 2
before completing the following procedure to ensure that all installation
Figure 3-2
and proceed as follows:
Table A-1
on page A-2 for recommended torque values to use when installing the
Chapter 2
para y asegúrese de
Advertisement
Table of Contents
