Attaching The Electrostatic Discharge Wrist Strap; Rack Mounting The Chassis; Esd Grounding Receptacle - Enterasys Matrix N3 7C103 Hardware Installation Manual

Figure 3-2 Rack Mounting the Chassis
À
Â
1 Chassis side rails
3.2.4

Attaching the Electrostatic Discharge Wrist Strap

The Electrostatic Discharge (ESD) wrist strap must be attached before handling the power
supplies, fan tray, and modules used in the N3 chassis. In addition, observe all precautions when
handling these modules to prevent damage from electrostatic discharge.
Refer to Figure 3-3. Place the ESD wrist strap on your wrist and plug the other end into the
grounding receptacle, at the top right corner of the chassis.
Figure 3-3 ESD Grounding Receptacle

1 ESD grounding receptacle

FAN
STATUS
7C203-1
PWR
REDUNDANCY
7C203-1
PWR
REDUNDANCY
2 Equipment rack or cabinet
Á
3 Rack mounting screws (7)
Á À
2 Chassis front panel
Setting Up the Chassis
À
100-125V~12.0A
200-240V~6.0A
50/60 Hz
100-125V~12.0A
200-240V~6.0A
50/60 Hz
Chassis Setup
Â
3-5