DFI RC300-CS User Manual page 38

RC ACPI Settings
Configure power management related settings in this page.
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
RC ACPI Settings
[Disabled]
Wake system from S5 via RTC
[S0 State]
State After G3
Virtual Battery [Enabled]
Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
Wake system from S5 via RTC
When Enabled, the system will automatically power up at a designated time every
day from the Real-time clock (RTC) battery. More settings will be displayed once
it's switched to [Enabled] as detailed in the next page.
State After G3
Select between S0 State, Last State, and S5 State. This field is used to specify
what state the system is set to return to when power is re-applied after a power
failure (G3 state).
Virtual Battery
Enable or disable virtual battery, it's for MXM RTX20xx and its above versions.
If enabled, the system supports S4(Suspend to disk mode) if WIN10 PCH driver
installed.
RC300-CS
Enable or disable Sys-
t e m w a k e o n a l a r m
event. When enabled,
System will wake on the
hr::min::sec specified
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
38
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
RC ACPI Settings
Wake system from S5 via RTC [Enabled]
Wake up hour
0
0
Wake up minute
Wake up second 0
State After G3 [S0 State]
Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
When "Wake system from S5" is enabled, the following fields will appear.
Wake up hour
Press +/- to set the hour from 0 to 23.
Wake up minute
Press +/- to set the minute from 0 to 59.
Wake up second
Press +/- to set the second from 0 to 59.
Select 0-23 For example
enter 3 for 3am and 15
for 3pm
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi.com