DFI RC300-CS User Manual page 40

PCH-FW Configuration
Configure the parameters of Management Engine Technology.
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
ME State [Enabled]
Manageability Features State [Enabled]
AMT BIOS Features [Enabled]
AMT Configuration

ME Unconfig on RTC Clear [Enabled]
Firmware Update Configuration

Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
ME State
Enable or disable Management Engine. When this field is set to Disabled, ME
will be put into ME Temporarily Disabled Mode. The following fields will only
appear when ME State is enabled.
Manageability Features State
Enable or disable Intel(R) Manageability features. This option disables/enables
Manageability Features support in FW. To disable, support platform must be
in an unprovisioned state first.
AMT BIOS Features
When disabled, AMT BIOS features are no longer supported and user is no
longer able to access MEBx Setup. This option does not disable manageability
features in FW.
► AMT Configuration
This section is used to configure Intel(R) Active Management Technology
Parameters. Please refer to the following pages.
ME Unconfig on RTC Clear
When disabled, ME will not be unconfigured on RTC Clear.
► Firmware Update Configuration
Please refer to the following pages.
RC300-CS
When Disabled ME will
be put into ME Temporar-
ily Disabled Mode.
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
40
► AMT Configuration
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
USB Provisioning of AMT [Disabled]
Secure Erase Configuration

OEM Flags Settings

Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
USB Provisioning of AMT
Enable or disable AMT USB Provisioning.
► Secure Erase Configuration
Please refer to the following pages.
► OEM Flags Settings
Please refer to the following pages.
Enable/Disable of AMT
USB Provisioning.
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi.com