Grizzly T33256 Owner's Manual page 30

To sand vertically on platen:
1. Refer to Adjusting Platen Tilt on Page 22 to
adjust platen to desired vertical position.
2.
Remove table lock handle, washer, and (2)
wing knobs from disc guard (see Figure 39)
to remove table from sanding disc position.
x 2
Figure 39. Location of table fasteners.
3. Remove cap screws and washers shown in
Figure 40 to remove work stop from platen.
Figure 40. Location of work stop cap screws and
washers.
-28-
x 2
4. Thread table stud into platen, as shown in
Figure 41.
Figure 41. Table stud installed in platen.
5. Attach table to platen and table stud with (2)
wing knobs, then thread table lock handle
through flat washer and into platen (see
Figure 42).
x 2
Figure 42. Table attached to platen and table
stud.
6. Refer to Calibrating Table Tilt on Page 38 to
square table to sanding belt.
7.
Adjust angle of table (and miter gauge, if
desired) for operation.
8. Connect machine to power, turn it ON, and
allow it to reach full speed.
9.
Place workpiece on table (and against miter
gauge, if used).
Model T33256 (Mfd. Since 04/22)
Table Stud
Table