Disc Sanding
The sanding disc can be used to create flat,
smooth ends and edges of workpieces.
Always keep workpiece on left side of wheel
that rotates down toward table. This will
keep workpiece from flying out of hands
due to kickback.
To reduce risk of fingers or workpiece
getting trapped between table and sanding
disc, adjust table within
To sand on disc:
1.
Adjust table and miter gauge (if using) to
desired angles for operation.
2.
Connect machine to power, turn it ON, and
allow motor to reach full speed.
3.
Place workpiece on table and firmly against
miter gauge (if using).
4.
With light pressure, slowly move workpiece
into left side of sanding disc. See Figures
26–29 for examples of disc sanding.
Figure 26. 90° disc sanding.
-24-
⁄
" of sanding disc.
1
16
Figure 27. Miter sanding.
Figure 28. Bevel sanding.
Figure 29. Sanding round workpiece.
Model T33256 (Mfd. Since 04/22)