Grizzly T33256 Owner's Manual page 41

3. Check to see if angle indicator points to zero
(see Figure 67).
— If angle indicator does not point to zero,
proceed to Step 4.
— If angle indicator does point to zero, table
tilt is calibrated correctly and no adjust-
ment is necessary.
4.
Loosen angle indicator Phillips head screw
(see Figure 67), adjust indicator to zero, then
tighten screw.
Angle
Indicator
Figure 67. Location of angle indicator and
Phillips head screw (disc table indicator shown).
Model T33256 (Mfd. Since 04/22)
Note: You may need to remove side cover
to access screw on platen table tilt indicator
(see Figure 68).
Side
Cover
Figure 68. Location of side cover.
-39-