Changing Sanding Disc - Grizzly T33256 Owner's Manual

Changing
Sanding Disc
The T33256 accepts 6" diameter PSA (pressure-
sensitive adhesive) sanding discs. Use the fol-
lowing steps to change the sanding disc when a
sanding disc wears out or your operation requires
a different grit size.
Items Needed
Hex Wrench 3mm .............................................. 1
Cleaner/Degreaser ............................ As Needed
Disposable Rags ............................... As Needed
To change sanding disc:
1. DISCONNECT MACHINE FROM POWER!
2. If table is installed for disc sanding, remove
table lock handle, washer, and (2) wing
knobs from disc guard (see Figure 23) to
remove table from sanding disc position.
x 2
Figure 23. Location of table fasteners.
Model T33256 (Mfd. Since 04/22)
3. Remove (4) button head cap screws shown in
Figure 24 to remove disc cover.
Qty
Disc Cover
Figure 24. Location of disc cover and cap
4. Peel old sanding disc off of aluminum disc.
5. Clean aluminum disc to remove any leftover
adhesive.
6. Peel backing off of new sanding disc, then
press adhesive side to center of aluminum
disc (see Figure 25), working from center
outward, making sure it contacts surface
evenly.
Figure 25. Sanding disc stuck to aluminum disc.
7.
Install disc cover with screws removed in
Step 3.
8.
Install table.
x 4
screws.
Sanding Disc
(Aluminum
Disc Hidden)
-23-