Grizzly T33256 Owner's Manual page 39

6. Loosen (4) motor cap screws to release
V-belt tension (see Figure 60).
— If V-belt is in good condition but there is
not ⁄ " of deflection, proceed to Step 14.
1
4
— If V-belt is cracked, torn, excessively worn,
damaged, proceed to Step 7.
x 4
Figure 60. Location of motor cap screws and
V-belt.
7. Remove V-belt from motor pulley, then turn
machine upright.
Note: Do not install machine base, it will be
installed in later step.
8. If table is installed for disc sanding, remove
table lock handle, washer, and (2) wing
knobs from disc guard (see Figure 61) to
remove table from sanding disc position.
x 2
Figure 61. Location of table fasteners.
Model T33256 (Mfd. Since 04/22)
V-Belt
9. Remove (4) button head cap screws shown in
Figure 62 to remove disc cover.
Disc Cover
Figure 62. Location of disc cover and cap
screws.
10. Pivot belt cover up, then loosen (2) set screws
shown in Figure 63 to remove aluminum disc
from drive shaft.
11. Remove V-belt from idler pulley (see Figure
63), then seat new V-belt in pulley.
Idler Pulley
Aluminum Disc
Figure 63. Sanding disc drive compo-
nents (other parts removed for clarity).
12. Install aluminum disc and disc cover.
13. Turn machine on its side and place new belt
around motor pulley.
14. Move motor to tension belt with
then tighten cap screws from Step 6.
15. Install machine base cover, then turn machine
upright.
16. Secure belt cover with screw removed in
Step 2.
x 4
Drive
Shaft
Set Screw
(1 of 2)
⁄ " deflection,
1
4
-37-