Maintenance
System check
NOTE
THE FOLLOWING INFORMATION REFERS TO ONE BRAKING CIRCUIT BUT APPLIES TO BOTH.
To carry out a quick pad check:
•
Park the vehicle on its centre stand.
•
Visually check the brake disc and pads, as indicated below.
Front brake callipers
From the front bottom side for both pads.
Rear brake calliper
From the back bottom side for both pads «1».
•
Replace both pads if the friction mate-
rial thickness (even in only one pad) is
reduced to about 1.5 mm.
Front pads "2".
Rear pads "3".
Headlight adjustment
For a quick check of the correct direction of the
front light beams, place the vehicle ten metres
from a vertical wall and make sure the ground is
level.
Turn on the low beam light, sit on the vehicle and
check that the light beam projected to the wall is a
little below the headlight horizontal straight line
(about 9/10 of the total height).
MAIN - 40
SCARABEO 125 - 200