APRILIA SCARABEO 125 Service Manual page 34

Maintenance
•
Place a collecting container under the
oil drainage plug «4».
•
Unscrew and remove the oil drainage
plug «4» and then drain all the engine
oil into the collecting container.
•
Remove the cover by undoing the 2
screws «3» and slide off the engine oil
filter.
•
Fit a new oil filter and the cover tight-
ening the two screws «3».
•
Screw and tighten the engine oil drain-
age plug «4».
CAUTION
UPON REFITTING THE OIL FILTER COVER PAY ATTEN-
TION NOT TO DAMAGE THE O-RING.
•
Pour approx. 950 cm³ (58 cu.in) engine oil through the fill opening «2».
•
Screw and tighten the measuring cap-dipstick «1».
•
Start the engine and let it run for several minutes. Stop the engine and let it cool down.
•
Check engine oil level again.
Check
NOTE
USE RECOMMENDED OIL ONLY. REFER TO THE RECOMMENDED PRODUCTS TABLE.
Do not exceed the ''MAX'' mark when topping-up engine oil.
•
Park the vehicle on firm and level ground.
•
Rest the vehicle on its centre stand.
CAUTION
WAIT SOME MINUTES UNTIL THE ENGINE AND THE EXHAUST SYSTEM ARE COLD.
MAIN - 34
SCARABEO 125 - 200