Table of Contents
Advertisement
Installation Overview
Installation Tools
Installation Procedure
NOTE
All cabling must be shielded.
Installing an iSTAR eX requires the following equipment:
Antistatic floor mat, tabletop mat, and wrist strap.
Standard tool kit
3/32" (2.4 mm) screwdriver to secure wires into input, output, and reader connectors.
Security screwdriver (contact Software House)
Small needlenose pliers; wire strippers.
Small Phillips screwdriver for LCD contacts,
5/16" (#10) nut driver (for securing shield wires to a ground stud)
To install an iSTAR eX
1. Unpack and mount the iSTAR eX enclosure.
2. Connect AC power.
3. Connect Wiegand signaling readers to the GCM, if required.
4. Connect inputs to the GCM, if required.
5. Connect output devices to the GCM relays, if required.
6. Connect output devices to the GCM OC outputs, if required.
7. Connect RM readers to the PMB, if required.
8. Connect I/8 and R/8 boards to the PMB, if required.
9. Connect to the host.
10. Configure the controller and cluster.
11. Configure readers, inputs, and outputs.
12. Complete the installation (secure wiring, remount cabinet door, etc.).
Installation Overview
1–19
Advertisement
Table of Contents
