Table of Contents
Advertisement
Communicator compatibility
Communicator
TL880LE
Note: Enter [*][8][Installer Code][900][000] at keypad to view the panel version number.
Installation requirements
Note:For equipment used at the protected premises and intended to facilitate IP communications (hubs,
routers, NIDs, Digital Subscriber Line (DSL), cable models), 24-hour back-up power is required. Where such
cannot be facilitated, a secondary (back-up) communication channel is required.
Follow these guidelines during installation.
Before affixing the communicator to a wall, verify the LTE signal level at the installation location. On a
l
keypad, press and hold the 5 key for 2 seconds to view the LTE signal level. An installation location with
a sustained signal level of two or more bars is recommended.
When using panel power for the TL880LE module, do not exceed the panel's maximum rated total output
l
power. Refer to the specified panel installation instructions for details. Only one module can be used per
panel.
Do not mount the TL880LE communicator inside of the metal alarm panel enclosure.
l
Receiver/
Panel
Sur-Gard System I-IP Receiver, version 1.13+
l
Sur-Gard System II Receiver, version 2.10+
l
Receiver
Sur-Gard SG-DRL3-IP, version 2.30+ (for Sur-Gard System III Receiver)
l
Sur-Gard SG-DRL4-IP version 1.20+ (for Sur-Gard System IV Receiver)
l
Sur-Gard SG-DRL5-IP version 1.00+ (for Sur-Gard System 5 Receiver)
l
HS2016, version 1.1+
l
HS2032, version 1.1+
l
Panel
HS2064, version 1.1+
l
HS2128, version 1.1+
l
Description
- 7 -
Advertisement
Table of Contents
