Table of Contents
Advertisement
Important Safety Information
Product Information
Compliance
NOTE
Operating problems are often caused by failure to ground system components properly.
Follow all instructions for grounding described in this Quick Start.
The following precautions apply to all procedures described in this manual.
1. To meet life safety requirements, a fail-safe mechanism override must be installed at each
card reader exit to allow people to leave the secure area in case of electromechanical
device failure.
2. The iSTAR eX device described in this manual could cause electrical shock. Installation
and maintenance should be performed only by qualified personnel. Make sure power is
removed before the system is installed.
3. The iSTAR eX and printed circuit boards in the reader devices are susceptible to damage
by static electricity. When handling these devices:
• Make sure your work area is safeguarded
• Transport all components in static-shielded containers
iSTAR eX is listed for use as a "Commercial, Proprietary, Multiplex (PSDN) Standard and
Encrypted Line Security Burglar Alarm System Control Unit and Access Control Unit."
The iSTAR eX communicates with the C•CURE 800/8000 and the C•CURE 9000 supervisory
equipment and has been evaluated for Line Security Encryption.
UL294, UL1076, CE, FCC, RoHS, FIPS 140-2
For all compatible devices, refer to the Installation and Configuration Guide (Doc No. UM-121)
Wiring Inputs and Outputs to the GCM
1–31
Advertisement
Table of Contents
