Table of Contents
Advertisement
TalkAnytime Quick Start Instructions
Phone/IP Details *Absolutely Needed*
Before Starting the Installation
The TalkAnytime will interface with both the IP network and the phone system. You must gather
information about the IP network and about the phone system so that the TalkAnytime can be configured
to operate with them properly. A summary of this configuration information appears on page 26 ("Config
Info CheckList").
Gather IP Information
Ask your computer network
administrator.
• IP Address
Note: The default IP address of TalkAnytime units
• IP Mask
• Gateway
• Domain Name Server (DNS) Info (optional)
• Determine whether or not 802.1p Packet Prioritization
will be used.
T1 Telephony Parameters (for TA2410)
The following parameters must be known about the PBX or telco central office equipment to which the T1
TalkAnytime unit will connect:
T1 Phone Parameters
Ask phone company or
PBX maintainer.
• Which frame format is used?
• Which CAS or PRI protocol is used? ______________
• Clocking: Does the PBX or telco switch use
internal
Note that the setting used in the TalkAnytime unit will
be the opposite of the setting used by the telco/PBX.
• Which line coding is used?
Write down the values for these T1 parameters. You will need to enter these values in the "T1/E1/ISDN
Parameters" screen in the Configuration section of the TalkAnytime software.
IP Network Parameters:
Record for this
TalkAnytime unit.
is 192.168.3.143.
Info needed to operate:
T1 Parameters:
Record for this
TalkAnytime unit.
___ or
ESF
or
clocking? _________________
external
___ or
AMI
TA2410
___
D4
___
B8ZS
23
Gathering Phone/IP Details
Advertisement
Table of Contents
