Typical Installation; General Information; Typical Installation For Models In Ordinary Locations - Graco QUANTM i30 Instructions Manual

Typical Installation

General Information

Typical installations are shown in F
figures are only guides for selecting and installing
system components. Contact your local distributor for
assistance in planning a system to suit your needs.

Typical Installation for Models in Ordinary Locations

A
F . 3: Typical Installation for Models in Ordinary Locations (cord and plug connection) (i30 (QTC) model shown)
IG
Pump Components
A Power cord
♦
B Fluid inlet port
C Fluid outlet port
D Mounting feet
E Ground fastener
K Fluid output control knob
L Diaphragm access ports (not shown)
▼
Connect to a circuit with a main electrical disconnect. Install
♦
a branch circuit protective device in each ungrounded
phase. Follow local codes and regulations.
See Install Monitoring Accessories, page 14, or Install
▼
Fluid Leak Line Accessories, page 14.
3A8572B
. 3 and F . 4. The
IG IG
N
K
E
Always use Genuine Graco Parts and accessories. Be
sure all accessories are adequately sized and
pressure-rated to meet the requirements of the system.
Reference letters in the text, for example, (A), refer to
the callouts in the figures.
C
J
L
B
D
Accessories (Not Supplied)
F* Conductive, flexible fluid supply line
G* Fluid drain valve
H Fluid shutoff valve
J* Conductive, flexible fluid outlet line
M Fluid pressure gauge
N I/O Cable
* Required, not supplied.
Typical Installation
M
G
F
H
11