Table of Contents
Advertisement
WARNING
Disconnect power to the unit before servicing following all lock out\tag out procedures established
by the user.Verify all power is off to the unit before performing any work.
Failure to comply could result in serious injury,death or damage to the equipment.
WARNING
Water and CO2 to the system must be turned off and the system depressurized prior to performing
this service.
Failure to comply could result in serious injury,death or damage to the equipment.
6. Install new motor by reversing this procedure.
C
ONTROLLER
1. Disconnect power to the unit.
2. Remove the following:
•
front merchandiser by removing screws on the top and lifting up
•
key switch wires
•
hood by removing screws on the top and lifting up and forward.
•
Screw on PCB cover
3. Push the cover off as arrow direction.
4. Unplug all connectors.
5. Squeeze all four standoffs
and
remove the board.
6. Install new controller board by
reversing this procedure.
© 2010, IMI Cornelius Inc.
B
R
OARD
EPLACEMENT
Screw
Connector
in each Corner
- 36 -
Advertisement
Table of Contents
